SKU 65057
For technical questions, please call 1-800-444-3353.
Page 3
plugs with grounded power tools.
Unmodified plugs and matching out
-
lets will reduce risk of electric shock.
avoid body contact with grounded
b.
surfaces such as pipes, radiators,
ranges and refrigerators.
There is
an increased risk of electric shock if
your body is grounded.
do not expose power tools to rain
c.
or wet conditions.
Water entering
a power tool will increase the risk of
electric shock.
do not abuse the cord. never use
d.
the cord for carrying, pulling or
unplugging the power tool. Keep
cord away from heat, oil, sharp
edges or moving parts.
Damaged
or entangled cords increase the risk
of electric shock.
When operating a power tool out-
e.
doors, use an extension cord suit-
able for outdoor use.
Use of a cord
suitable for outdoor use reduces the
risk of electric shock.
if operating a power tool in a damp
f.
location is unavoidable, use a
ground Fault circuit interrupter
(gFci) protected supply.
Use of
a GFCI reduces the risk of electric
shock.
personal safety
3.
Stay alert, watch what you are do-
a.
ing and use common sense when
operating a power tool. do not use
a power tool while you are tired
or under the influence of drugs,
alcohol or medication.
A moment
of inattention while operating power
tools may result in serious personal
injury.
use personal protective equip-
b.
ment. always wear eye protection.
Safety equipment such as dust mask,
non-skid safety shoes, hard hat, or
hearing protection used for appropri
-
ate conditions will reduce personal
injuries.
Remove any adjusting key or
c.
wrench before turning the power
tool on.
A wrench or a key left at-
tached to a rotating part of the power
tool may result in personal injury.
do not overreach. Keep proper
d.
footing and balance at all times.
This enables better control of the
power tool in unexpected situations.
only use safety equipment that
e.
has been approved by an appropri-
ate standards agency.
Unapproved
safety equipment may not provide
adequate protection. Eye protection
must be ANSI-approved and breath
-
ing protection must be NIOSH-ap
-
proved for the specific hazards in the
work area.
power tool use and care
4.
do not force the power tool. use
a.
the correct power tool for your ap-
plication.
The correct power tool will
do the job better and safer at the rate
for which it was designed.
do not use the power tool it does
b.
not turn on and off.
Any power tool
that cannot be controlled dangerous
and must be repaired.
disconnect the plug from the
c.
power source before making any
adjustments, changing accesso-
ries, or storing power tools.
Such
preventive safety measures reduce
the risk of starting the power tool ac
-
cidentally.
Store idle power tools out of the
d.
reach of children and do not allow
