Chicago Dryer King Edge VAc, Инструкция по эксплуатации

Страница: 25 / 302

King Edge Vac Installation
2-7
Figure 2-13: Two bolts secure the upper pulley arm
in position.
Figure 2-14: After positioning the pulley, roll the
inlet conveyor belt into place.
B
A
Floor Trough Installation
Now it is time to install the floor trough which
will catch wet linen which is dropped during
processing.
Install the four trough brackets which
shipped with the machine, two in front
and two in the back, on the crossbars. If
necessary, push the front bypass conveyor
forward a little to seat the rear brackets.
Position them about 12-18” (305-460 mm)
away from each endframe and facing each
other (Figure 2-11).
Slide the galvanized steel trough into posi-
tion so that it is firmly resting on the sup-
port brackets (Figure 2-12. Make sure the
angled corners face the machine front.
1.
2.
3.
Inlet Conveyor Upper Pulley
Installation
For facilities with low clearance, the inlet
conveyor upper pulleys are sometimes reversed
for shipping (Figure 2-13). They must be correctly
positioned before connecting the utilities.
Required Tools
wrench
Remove the two bolts which secure each
upper pulley arm in position (Figure 2-
13).
Turn the arm so the pulley is on top and
re-install using the same two bolts.
Pull the drive belt over the rim of the pul-
ley (Figure 2-14, A) and roll it into posi-
tion. Make sure it is positioned within the
safety stop mechanism (B).
1.
2.
3.
Figure 2-11 Position the floor troughs facing each
other about 12-18” from the endframe.
Figure 2-12: The angled corners must face front to
accommodate the locking floor pads.
TOC INDEX