Chevrolet 2000 Monte Carlo, Руководство пользователя, Страница: 123 / 370

2-57
To program a garage door opener with the rolling code
feature, do the following:
1. Program your hand
-
held transmitter to the
HomeLink
R
Transmitter by following the steps
provided under “Programming the Transmitter”
earlier in this section.
2. Remove the cover panel from the garage door
opener receiver. It is located near the garage door
opener motor.
3. Locate the training button on the garage door
opener receiver. The exact location and color will
vary among brands.
4. Press the training button on the garage door opener
receiver for one to two seconds.
5. Within thirty seconds of pressing the training button,
return to your vehicle and press the programmed
button on the HomeLink
R
Transmitter until the
indicator light flashes rapidly (about two seconds).
6. Release the button, then press it again to confirm it
was programmed to the garage door opener receiver.
You may now use either the HomeLink
R
Transmitter
or the hand
-
held transmitter to open your garage door.
If you still have difficulty in programming and require
assistance, please call 1
-
800
-
355
-
3515.
Erasing Channels
To erase all three programmed channels, hold down the
two outside buttons until the indicator light begins to
flash. Individual channels cannot be erased, but can be
reprogrammed using the procedure for programming
the transmitter explained earlier.
Accessories
Accessories for the HomeLink
R
Transmitter are available
from the manufacturer of the unit. If you would like
additional information, please call 1
-
800
-
355
-
3515.