Tel : (800)-444-5969
www.cheviotproducts.com
CARE AND MAINTENANCE
Minimum Maintenance is required to maintain product finish. With proper
maintenance your CHEVIOT Faucet will continually look like new. Special care
should be taken when cleaning your faucet and the following suggestions should help
extend your faucet life.
a) Cleaning should be done regularly using a soft cotton cloth and warm water, then
towel dry.
b) Do not use cleaners that contain abrasives or harsh chemicals; Care should be
taken in selecting cleaning supplies. Many cleaners contain detergents, ammonia, or
other corrosive solvents that could damage your faucet finish.
c) occasionally clean with a non-abrasive wax polish.
Model # 5115-L
EV
INSTRUCTIONS
1. Attach the S-Union to the tub with flat
metal washer and 1/2” lock nut. Make
sure that escutcheon is tight against
S-Union arm (hand tighten only).
2. Attach faucet to S-Unions (3/4“
washers must be installed) and adjust
faucet so that it sits level. Now tighten
hex nuts on back of faucet to secure the
S-Unions. Then tighten the 1/2” lock
nuts on the back of the S-Unions to
secure faucet on vertical surface.
3. Next connect the water supply lines.
Must have hot going to hot side & cold
to the cold side. If using 1/2“ OD
decorative supply line connect the hex
nuts at the top of the supply lines to the
back of the S-Unions. If installing inside
the wall use copper fittings.
4. Install the hand shower cradle on to
the top of the faucet body. Place the
rubber washer in the hex nut at the base
of the cradle and tighten until sealed and
secure.
5. To install the shower hose place the
1/2” rubber washers in the cone nuts at
both ends of the shower hose. Install
one end to the side port on the cradle
stand and one end to the bottom of the
hand shower. Hand tighten.
6. Once installed, remove aerator and
hand shower to flush faucet and water
lines. This will remove any debris that
may be trapped. Then attach shower
head and aerator.
1
13"
6 1
_
2
"
6"
3"
5 1
_
4
"
2 3
_
4
"
8"
2 3
_
4
"
5
_
8
"
4 5
_
8
"
8 3
_
8
"
4 1
_
8
"
rubber
2 1
_
2
"
37
_
8
"
2 1
_
4
"
Note: S Unions allow 3” to 8” Centers
C
Backflow prevention device