9
2 Follow the instructions in the software.
3 Set the switch on the bottom of the mouse to
BT
.
4 Activate the Bluetooth connection of the mouse
by pressing the button on the bottom of the
mouse.
The blue LED on the mouse flashes quickly.
If the blue LED does not flash:
• There is already a connection between the
mouse and another PC/laptop. Switch off this
PC/laptop or deactivate the connection on this
PC/laptop.
5 Follow the instructions in the software.
The LED stops glowing and the mouse is connected
with your PC/laptop.
If the red LED of the mouse flashes quickly, the
connection has failed.
• Try to establish the connection again.
3.2 Connecting the mouse via the
receiver
The receiver is in a compartment on the bottom of
the mouse and is held in place by magnets.
1 Pull the receiver out of the housing.
2 Connect the receiver to the USB socket on the
PC/laptop.
3 Set the switch on the bottom of the mouse to
RF
.
The mouse is connected with your PC/laptop.
4 Adjusting the sensitivity
of the mouse
(DPI number)
You can adjust the resolution of the sensor
according to your needs.This changes the speed of
the mouse pointer.
• Press the DPI button on the top of the mouse.
The LED flashes depending on the setting:
1x = 600 dpi
2x = 1000 dpi
3x = 1600 dpi
4x = 3200 dpi
The setting is saved in the mouse and is retained
even when the mouse is switched off.
5 Charging the mouse
When the red LED flashes slowly, you should
charge the mouse soon. The faster the red LED
flashes, the lower the charging status of the
battery.
• Connect the charging cable to the mouse and a
USB socket on the PC/laptop.
The LED glows as long as the mouse is being
charged. When the mouse is fully charged, the LED
stops glowing.
The battery will be charged as long as the PC/
laptop is switched on. You can continue working
while the mouse is charging.
6 Switching the mouse
on/off
The
CHERRY MW 8 ADVANCED
switches to a sleep
mode, which requires nearly no energy, when it is
not in use. It switches on again automatically the
first time a button is pressed.
However, it still consumes power in the energy-
saving mode, therefore you should switch it off
manually for longer periods of disuse or for
transporting.
• Push the switch on the bottom of the mouse to
the corresponding position:
Off
Wireless on = RF
Bluetooth on = BT
7 Tips
7.1 Storing the receiver in the mouse
The receiver is so small that it can stay in the USB
socket of a laptop while being transported. To avoid
any damage, you can also pull out the receiver and
deposit it in the mouse to protect it from dirt and
loss (see overview page).
Wake-up function with Bluetooth
If your PC/laptop is in standby mode, it
is not possible to wake them up using
Bluetooth devices.
EN
