The following is an outline of the three menus and the modes contained within each
menu. Use this chart to quickly identify the location and proper path to access any of
the settings.
RUN MENU
•
I
– displays the force currently measured by the load cell.
•
A
– displays the average force measured from a test.
•
H
– displays the maximum force measured from a test.
•
L
– displays the minimum force measured from a test.
PRINT MENU
•
P
– transfers the selected test’s data to the connected PC through the RS232
port.
•
St
– turns data storage on or off.
•
dL
– deletes all stored test data.
SETUP MENU
•
F
– calibrates the load cell.
o
LC
– records the low calibration point.
o
HC
– records the high calibration point.
•
dT
– sets the dwell time.
•
bE
– turns the beeper on or off.
There is also a Units key that allows you to change the unit of measure to any of the five
choices: Kilograms, Grams, Newtons, Pounds, and Ounces. The green LED lights to
the right of the display indicate the current active unit of measure.
8 |
P a g e
Probe Tack Tester Operating Instructions (PT-1000)
