C
OLLOID
M
ILL
I. O. & M
12
d. Remove the large, upper bearing l ocknut, slinger
and retaining snap ring.
e. The shaft with bearing intact may now be
gently
slipped from the upper end (m ill side not m otor
side) of the bearing sleeve.
(A rubber mallet may be required.)
f. Remove the lower locknut and press the upper and
lower bearings from the shaft.
9. Further disassem bly is not required for sta
ndard
maintenance. Gear housi ng and adjustm ent gearing
failures are not typical. Shoul d you need to disassem ble
the shaft adjustmen t gearing, please con sult the factory
for guidance.
C
OLLOID
M
ILL
R
E
-A
SSEMBLY
Reassembly may be completed by reversing the above procedure.
1. Shaft, Bearing and Bearing Housing Configuration
a. There are two o-rings located
withi n the bearing housi ng,
replace if necessary.
b. Lightly grease the shaft bearing seats.
