Chekline WT3-201M, Руководство пользователя, Страница: 6 / 34

Model WT3-201M Motorized Wire Crimp Pull Tester User’s Guide
5
Further instructions for configuring and using the gauge’s outputs are provided in the Communications
and Outputs section.
3.4 Connecting power
Plug one end of the power cord into its receptacle at the rear of the stand and the other end into a wall
outlet with local earth ground (3-prong connector).
Before turning on power, the following safety checks and procedures should be performed:
1. Never operate the tester if there is any visible damage to the power cord or the tester itself.
The WT3-201M is powered by 110V/220V. Any contact with this high voltage can cause
serious injury or even death.
2. Ensure that the tester is kept away from water or any electrically conductive liquids at all
times.
3. Make sure the electrical outlet powering the tester has local earth ground (3-prong connector).
4. The tester should be serviced by a trained technician only. Power must be disconnected
before disassembly.
After the above safety checks and procedures have been performed, the tester may be powered on and
is ready for operation.
4 HOME SCREEN AND CONTROLS
4.1 Demo Mode Functions
The WT3-201M is shipped in Demo Mode , which provides full functionality of all available functions for an
evaluation period of 160 operating hours. When this period has expired, any functions not purchased will
no longer be accessible.
After the initial power-up sequence, the display appears as follows:
The available optional functions are as follows:
1. Profiles
Save and recall sets of test parameters, such as speed, pass/fail limits, unit of measurement, etc.
Maximum of 500 profiles may be stored.
2. Load Holding
The tester will stop and maintain a specified load for a specified period of time.
3. Pull To Load
The tester will stop when the specified load has been reached.
*** DEMO MODE ***
All functions are
temporarily enabled.
Remaining demo time:
160 hours
Press ENTER.