7
8
RJ14-4-GB
RJ14-4-GB
HOW TO USE
1.
Fill glass coffee carafe with desired amount of filtered water.
TIP: Use the water measurement markings on the carafe as a guide.
2. Open the water tank lid.
3. Use the carafe to carefully fill the water tank. Close the lid. Place carafe on the warming plate.
4. Press the lid release button and pull lid up to remove.
5. Ensure the coffee filter is securely snapped into place.
6. Place the desired amount of coffee beans or grounds into the back of the grind basket
where the blade and coffee filter are located. Put 1 scoop of whole coffee beans or ground
coffee per 1 cup of water into the back of the grind basket where the blade and coffee
filter are located. (The brewed, filtered coffee travels through the front portion of the
grind basket and into the carafe.)
7. Reattach the lid by placing the water pump spout into the hole on the right of the grind
basket. Hold the lid release button and push down until the lid is securely in place.
(See Figure 1.)
8. Use the control dial to select corresponding brew setting and amount. If using ground
coffee, use the “Grounds” setting. If using whole coffee beans, select the “Bean, 1-2
Scoops” setting or the “Bean, 3-4 Scoops” setting depending on the amount of beans or
grounds being used. The blue indicator light will illuminate.
9. Press the start button. Once START is selected, the blue indicator light will flash for the
duration of the grind (if using) and brew cycle. Once the Coffee Maker beeps three
times and the blue indicator light stops flashing, coffee is ready.
Warning:
Do not place face, hands or any other body part over the steam vent while
coffee is brewing—steam is hot and can cause burns.
10. When blue indicator light stops flashing, carefully remove carafe from warming plate.
Warming plate will remain on and heated for up to 30 minutes.
Warning:
Use caution when pouring coffee—it will be very hot!
11. Turn Coffee Maker off by setting the control dial to OFF.
12. Allow Coffee Maker to cool completely before cleaning.
OPERATING INSTRUCTIONS
OPERATING INSTRUCTIONS
HOW TO REMOVE AND REATTACH COFFEE FILTER
1.
To remove coffee filter, use the coffee filter’s handle to lift up and unsnap.
(See Figure 6.)
2. To reattach coffee filter, position the coffee filter’s handle toward the front of
the Coffee Maker. Use the coffee filter’s handle to place coffee filter into the
back of the grind basket. Push down to snap into place. (See Figure 7.)
HOW TO REMOVE AND REATTACH GRIND BASKET
1.
To remove grind basket, first remove lid. Then twist the grind basket to the right
and lift to remove. (See Figure 5.)
2. To reattach grind basket, position the grind basket over the grind basket holder
on a 45 degree angle with the blade portion positioned in the back. Push the
basket into the grind basket holder; turn to the left to lock into place.
(Figure 5)
(Figure 6)
(Figure 7)
