Checkline humimeter RH5, Руководство по эксплуатации, Страница: 25 / 48

Page 25
6.5 Viewing individual readings from a series of measurements
To do so: You must have saved a series of measurements
(e.g. 2 logs ). The display will now appear as shown in
figure 30 .
1. Press .
2. Navigate to the required measurement series. To
do so, press or .
» The display will now appear as shown in figure 31 .
3. Press to switch to another input level.
» The display will now appear as shown in figure 32 .
4. Press again.
» The display will now appear as shown in figure 33 .
5. Navigate to the required reading ( No.: 1, No.: 2, No.:
3 ). To do so, press .
6. Press to leave this screen.
6.6 Deleting all measured values (data log)
To do so: You must have taken and saved one or several
readings.
1. Press twice or hold for 2 seconds.
2. Select Edit Logs (figure 34 ). To do so, press or
and confirm by pressing .
3. Select Clear Logs (figure 35 ). To do so, press or
and confirm by pressing .
»
The display will then show the message clear?
(figure 36 ).
4. Confirm by pressing .
» The data log has been deleted.
30
31
32
33
34
35
36