Checkline humimeter RH5, Руководство по эксплуатации, Страница: 16 / 48

humimeter RH5 & RH5.1 Operating Manual
Page 16
5. The measuring process
5.1 Taking a measurement on a stack
To do so: Let your humimeter device adjust to the sur-
rounding temperature of the product being measured
before the measurement (see
"5.2 Adjustment behaviour
of the sensor" ).
1. Take hold of the device with one hand and insert
the sword sensor 10 cm into the stack (figure 7 ).
»
Make sure to push the sword sensor straight into
the stack to prevent bending of the aluminium
sword.
»
In case of heavy stacks, use the optionally available
sword sensor holder and the tool for removing the
sword sensor holder (figure
8 ).
2. Push the sword a few centimetres further into the
stack at short intervals (approx. 10 seconds)
(figure
9 ).
3. Let the device adjust to the material being measu-
red for an adequate time period (see "5.2 Adjust-
ment behaviour of the sensor" ).
4. Now take the measured values shown on the display of the device.
»
Once the reading has been taken, it can be saved on the device (see "6.2 Saving
your readings manually" or "6.3 Auto save function (time-based)" ).
ATTENTION
Damage to the aluminium sword
The aluminium sword can be bent by pushing it in or out at an angle.
►
Push the aluminium sword straight into the material and pull it straight out
of the material.
7
8
9