Step 6: Installing the Software
Check Point 61000 Security System Getting Started Guide R75.40VS for 61000 | 53
CHAPTE R 8
Step 6: Installing the Software
In This Section:
Before Installing SSM160 Firmware and Software
....................................................
........................................................................................
.............................................................................................
If you Scalable Platform is equipped with SSM160, you must install the SSM160 firmware. Then
continue with
Installing the SGM Image
on page
Before Installing SSM160 Firmware and Software
Installing hardware components and connecting cables:
1.
Install all hardware components into the Chassis (SGMs, SSMs and CMMs).
See
Step 3: Installing Hardware Components and Connecting Power Cables
(on page
).
2.
If you have a dual Chassis environment, connect one Sync cable between both Chassis:
•
Connect
eth1-Sync
on
chassis1
to
eth1-Sync
on
chassis2
.
3.
For IP management of the 61000 Security System, connect a cable to one of the management
interfaces on
chassis1
:
•
Connect to the
eth1-Mgmt1
, if using a 10Gbps network
•
Connect to the
eth1-Mgmt4
, if using a 1Gbps network
Connecting over Console (Serial)
See
Connecting over Console (Serial) Port
.
Configuring a Security Group and a Management IP Address
1.
Start the installation wizard. Run:
# setup
2.
In the
Welcome
screen, press any key.
3.
Select
Set SGMs for Security Group
Define the SGMs that belong to the Security Group. There are two lines, one for Chassis 1, one
for Chassis 2.
In each line, you can enter:
•
all
(same as
1-12)
•
A range, such as:
1-9
•
A number of comma-separated ranges, such as:
1-3,5-7
•
Single SGMS, such as:
1,4
•
A combination of single SGMs and ranges, such as:
10,2,3-7
.
By default, the SGM you are connected to belongs to the group:
Chassis 1, SGM 1
(Slot 1 in
Chassis 1).
For more about Security Gateway Module numbering, see
61000 Security System Front Panel
Modules
).
