Table of Contents
16000 Appliances Getting Started Guide | 7
Safety, Environmental, and
Electronic Emissions Notices
Read the following warnings before setting up or using the appliance.
Warning
- Do not block air vents. A minimum 1/2-inch clearance is required.
Warning
- Many components described in this document can be damaged by Electrostatic Discharge
(ESD). Follow the precautions described here and before specific procedures detailed in the document to
protect static-sensitive components from ESD-related damage.
The machine can only be used in a restricted access location and has installation instructions by a skilled
person.
Before you install or remove a chassis, or work near power supplies, turn off the power and unplug the
power cord.
To prevent damage to any system board, it is important to handle it with care. The following measures are
generally sufficient to protect your equipment from static electricity discharge:
n
This equipment must be grounded.
n
When handling the board, to use a grounded wrist strap designed for static discharge elimination.
n
Touch a grounded metal object before removing the board from the antistatic bag.
n
Handle the board by its edges only. Do not touch its components, peripheral chips, memory
modules or gold contacts.
n
When handling processor chips or memory modules, avoid touching their pins or gold edge fingers.
n
Restore the communications appliance system board and peripherals back into the antistatic bag
when they are not in use or not installed in the chassis. Some circuitry on the system board can
continue operating even though the power is switched off.
n
Disconnect the system board power supply from its power source before you connect or disconnect
cables or install or remove any system board components. Failure to do this can result in personnel
injury or equipment damage.
n
Avoid short-circuiting the lithium battery; this can cause it to superheat and cause burns if touched.
n
Do not operate the processor without a thermal solution. Damage to the processor can occur in
seconds.
n
Class 1 laser product warning - A totally enclosed laser system containing a class 1 laser.
This device is not intended for use in the direct field of view at visual display workplaces. To avoid
incommoding reflexions at visual display workplaces this device must not be placed in the direct field of
view.
