Electromatic Equipment Co., Inc.
-8-
6.0
CHANGING BATTERIES
Your new device is provided with batteries.
Change of batteries:
1. Press with your finger onto the arrow of the battery
cap and pull it back.
2. Remove the empty batteries.
3. Put four new batteries in the device. Make sure the
position of the battery poles is correct.
4. Press down the batteries and close the cap.
7.0
DETERMINATION OF THE MATERIAL REFERENCE MOISTURE
The principle is a comparison measurement with the dehydration method according
to CEN/TS 14774. Take the measured sample and weigh it. Dry it out in an oven
and weigh it again.
M
n
: Mass with average moisture content
M
t
: Mass of the dried sample
%F : Calculated absolute moisture
Exemption from liability
For miss-readings and wrong measurements and of this resulting damage we refuse
any liability. This is a device for quick determination of moisture. The moisture
depends on multiple conditions and multiple materials. Therefore we recommend a
plausibility check of the measuring results. Each device includes a serial number
and the guarantee stamp. If those are broken, no claims for guarantee can be
made. In case of a faulty device, please contact Electromatic.
%F =
x 100
M
n
- M
t
M
n
Electromatic Equipment Co., Inc.
-9-
8.0
TRANSFER SAVED DATA TO THE PC
(Only possible with humimeter serial interface module)
To send your saved logs to your PC, connect the
humimeter-device to your PC using the cable that
was delivered with your device. You can either
connect it directly to a serial port on your PC or use
the enclosed serial-USB adapter.
Start the LogMemorizer software on your PC.
For installation and the required settings, please have
a look at the separate LogMemorizer manual.
Press the
-key until you reach the menu (as in the
image on the right). Then choose „Send Logs“ from
the menu and confirm with
.
Now you can choose “Manual Logs” and confirm with
again. The selected Logs will be sent to your PC.
If no transmission is performed, please check your
cable connection and the LogMemorizer settings and
try again.
If your device supports online-sending, this can be
activated in the menu „Options“. If the option is
active, every newly recorded log will immediately be
sent to your PC.
