Setup
-8-
Q-Spot™ 560-LED User Manual Rev. 08
3. Setup
AC Power
The Q-Spot™ 560-LED has an auto-ranging power supply that works with an input voltage
range of 100~240 VAC, 50/60 Hz.
Make sure that you are connecting this product to the proper voltage, as per the
specifications in this manual or on the product’s sticker.
Always connect this product to a protected circuit with an appropriate electrical
ground to avoid the risk of electrocution or fire.
To determine the power requirements for the Q-Spot™ 560-LED, refer to the label affixed
to the side of the product. You can also refer to the
Technical Specifications
chart in the
Technical Information
chapter of this manual.
The listed current rating indicates the maximum current draw during normal operation. For
more information, you may download the document
Sizing the Circuit Breakers
from the
CHAUVET® website:
www.chauvetpro.com
.
Never connect this product to a rheostat (variable resistor) or dimmer circuit, even if
the rheostat or dimmer channel serves only as a 0 to 100% switch.
AC Plug
The Q-Spot™ 560-LED comes with a power input cord terminated with a IEC connector on
one end and an Edison plug on the other end (US market). If the power input cord that
came with your product has no plug or you need to change the Edison plug, use the table
below to wire the new plug.
Connection
Wire (US)
Wire (Europe)
Screw Color
AC Live
Black
Brown
Yellow or Brass
AC Neutral
White
Blue
Silver
AC Ground
Green/Yellow
Green/Yellow
Green
Fuse Replacement
This product uses a T5 A, 250 V fuse.
Make sure to disconnect the product’s power cord before replacing a blown fuse,
and always replace with a fuse of the same type and rating.
1. Disconnect the product from the power outlet.
2. Wedge the tip of a flat head screwdriver into the slot of the fuse holder.
3. Pry the safety cap out of the housing to pull out the installed fuse.
4. Remove the blown fuse from the safety cap and replace with a fuse of the exact same
type and rating (T5 A, 250 V).
5. Insert the fuse holder back in place and reconnect power.
Installed fuse
(held by plastic clip)
Spare fuse
(
inside safety cap
)
Safety cap
