Front View
Rear View
Congratulations on the purchase of your new CHAUVET lighting effect. We are confident you will
enjoy many trouble free hours with this unit. To assist with the care and use of the product we have
prepared this short guide.
Operation
Before connecting this unit to the mains power supply for the first time you must first install the
lamps. (See ʻReplacing Lampsʼ for details).
This lighting effect has been designed to function on a mains power supply of either 120V~60Hz or
230V~50Hz and has been fitted with a suitable power plug for use with your local voltage. Check the
label and voltage selector switch (if fitted) on the unit and the power plug for the correct voltage.
When connected to the mains power supply the unit should illuminate. This effect has two modes of
operation - static or continuous scanning. There is a selector switch at the rear which determines the
mode (see fig.1).
Due to the high operating temperature of halogen lamps it is advisable that the effect be used in well
ventilated areas taking care not to obstruct the air vents. After use allow time to ʻcoolʼ for safety and
to ensure lamp life before moving or touching.
The duty cycle for this effect should be no more than 15 minutes on then 15 minutes off.
Use in a well-ventilated area without obstruction to air vents or fan.
On Front:
•Scanning Range Post
•Scanning Mirror
• Lens
On Bottom
•Funtion Switch
•Fuse Holder
•Fan
On Back:
• Bracket Screws
• Cable to Head
• Dichroic Filter Holder
•Gobo Holder
•Lamp Replacement
Cover
