Operation
Ovation™ F-165WW User Manual Rev. 2
-13-
Reset
To reset the Ovation™ F-165WW to the factory default settings, follow the instructions
below.
1. Go to the
SET
main level.
2. Select the
REST
programming level and then the display becomes blank.
Enter the passcode as described in
Passcode
. After successfully entering the
passcode,
REST
blinks on the display during the reset process.
3.
OK
appears on the display when finished.
Zoom - Menu
Control
The Ovation™ F-165WW offers three zoom options during the operation of the
Ovation™ F-165WW. To select from these option, do the following.
1. Go to the
SET
main level.
2. Select the
ZOOM
programming level.
3. Select from the following options:
•
Select
BASE
for the default zoom position (full movement).
•
Select
POS1
for the position 1 zoom range.
•
Select
POS2
for the position 2 zoom range.
Setting Zoom Ranges
These settings allow you to select the zoom ranges for POS1 and POS2 during menu
control of the zoom.
1. Go to the
CAL
main level.
2. Enter the passcode as described in
Passcode
.
3. Go to the
CALZ
programming level.
4. Select
POS1
(position 1) or
POS2
(position 2)
5. Select the desired maximum for the zoom
000
–
255
(0–100%).
6. Repeat to select the other position setting.
Resetting the Zoom
Motor
To reset the zoom’s motor, do the following.
1. Go to the
MOTR
main level.
2. Select
YES
to reset the zoom’s motor.
Note:
Selecting
NO
does not reset the zoom’s motor.
Zoom - Manual
Control
Manually adjust the zoom by using the zoom adjustment knob, as follows.
1. Press the zoom adjustment knob above the display twice.
2. Select the desired zoom setting
Z.000
–
Z.100
(0–100%).
•
When using the zoom adjustment knob, the lowest zoom value stops at D.000 and
the highest zoom value stops at D.100.
•
During manual zoom control, you can also use <UP> or <DOWN>, which will cycle
through all the zoom values.
•
After 30 seconds of zoom adjustment knob inactivity, M. appears on the display.
Performance Power
Output Options
The Ovation™ F-165WW offers three power output options during the cooling of the
fixture’s LEDs.
1. Go to the
SET
main level.
2. Select the
PERF
programming level.
3. Select from the following options:
•
Select
LIVE
to cool the LEDs by balancing the use of the fan and the power
output level.
•
Select
STDO
to cool the LEDs by limiting the use of the fan and limiting the
power output level.
•
Select
POWR
to cool the LEDs with full use of the fan and allowing full power
output.
