6
5.3 Universal DMX Controller
If you use a universal DMX controller to control the units, you have to set DMX address
from 1 to 512 channel so that the units can receive DMX signal.
Press the
MENU
button up to when the
is shown on the display. Pressing
ENTER
button and the
display will blink. Use
DOWN
and
UP
button to change the DMX512 address. Once the address has been
selected, press and keep
ENTER
button pressed up to when the display stops blinking or storing automatically 8
seconds later. To go back to the functions without any change press the
MENU
button again.
Please refer to
the following diagram
to address your DMX512 channel for the first 4 units.
5. How To Control The Unit
You can operate the unit in three ways:
1. By master/slave built-in preprogram function
2. By easy controller
3. By universal DMX controller
No need to turn the unit off when you change the DMX address, as new DMX address
setting will be effected at once. Every time you turn the unit on, it will show AE-5 on the display
and move all the motors to their ‘home’ position and you may hear some noises for about 20
seconds. After that the unit will be ready to receive DMX signal or run the built in programs.
5.1 Master/Slaver Built In Preprogrammed Function
By linking the units in master/slave connection, the first unit will control the other units to
give an automatic, sound activated, synchronized light show. This function is good when you
want an instant show. You have to set the first unit in master mode
and select
(show 1) or
(show 2) mode. Its DMX input jack will have nothing plugged into it, and Its
master LED will be constantly on and sound LED will flash to the music. The other units will
have to set in slave mode
and select
(normal) or
(2 light show) mode,
Their DMX cables plugged into the DMX input jacks (daisy chain) and the slave led lights will
constantly on.
2-light show
In
(slave mode),
means the unit works normally and
means 2-light
show. In order to create a great light show, you can set
on the second unit to get
contrast movement to each other, even if you have two units only.
4.2 Main Function
To select any of the given functions, press the
MENU
button up to when the required one is
shown on the display. Select the function by
ENTER
button and the display will blink. Use
DOWN
and
UP
button to change the mode. Once the required mode has been selected, press
the
ENTER
button to setup or it will automatically return to the main functions without any
change after idling 8 seconds. To go back to the functions without any change press the
MENU
button. The main functions are shown below:
MENU
Focus Adjust
Self-Test
Reset
Fixture Hours
Display Inversion
Display Normal
Tilt Inversion
Tilt Normal
Pan Inversion
Pan Normal
Slave mode " 2 Light Show 2 "
Slave Mode " Normal "
Show Mode " Show 2 "
Show Mode " Show 1 "
DMX512 Address Setting
DMX512 Address Setting
Press the
MENU
button up to when the
is shown on the display. Pressing
ENTER
button and the display will blink. Use
DOWN
and
UP
button to change the DMX512 address.
