LED-PAR200B User Manual
3
2010-03-09/15:03
1.
B
EFORE
Y
OU
B
EGIN
What is included
1 x LED-PAR200B
1 x Warranty Card
1 x Users Manual
Unpacking Instructions
Immediately upon receiving a product, carefully unpack the carton, check the contents to ensure that
all parts are present, and have been received in good condition. Notify the shipper immediately and
retain packing material for inspection if any parts appear damaged from shipping or the carton itself
shows signs of mishandling. Save the carton and all packing materials. In the event that a fixture
must be returned to the factory, it is important that the fixture be returned in the original factory box
and packing.
AC Power
To determine the power requirements for a particular product, see the label affixed to the back plate
of the product or refer to the
product’s specifications chart. A product’s listed current rating is its
average current draw under normal conditions. All fixtures must be powered directly off a switched
circuit and cannot be run off a rheostat (variable resistor) or dimmer circuit, even if the rheostat or
dimmer channel is used solely for a 0% to 100% switch. Before applying power, check that the source
voltage matches the
product’s requirement. Check the product or device carefully to make sure that if
a voltage selection switch exists that it is set to the correct line voltage you will use.
Warning!
All fixtures must be connected to circuits with a suitable Earth Ground.
Safety Instructions
Please keep this User Guide for future consultation. If
you sell the unit to another user, be sure that they
also receive this instruction booklet.
Always make sure that you are connecting to the
proper voltage and that the line voltage you are
connecting to is not higher than that stated on decal
or rear panel of the fixture.
This product is intended for indoor use only! To
prevent risk of fire or shock, do not expose fixture to
rain or moisture.
Make sure there are no flammable materials close to
the unit while operating.
The unit must be installed in a location with adequate
ventilation, at least 50 cm from adjacent surfaces. Be
sure that no ventilation slots are blocked.
Secure fixture to fastening device using a safety
chain.
Maximum ambient temperature is Ta: 40
°
C. Do not
operate fixture at temperatures higher than this.
In the event of serious operating problem, stop using
the unit immediately. Never try to repair the unit by
yourself. Repairs carried out by unskilled people can
lead to damage or malfunction. Please contact the
nearest authorized technical assistance center.
Don’t connect the device to a dimmer pack.
Make sure power cord is never crimped or damaged.
Never disconnect power cord by pulling or tugging on
the cord.
Avoid direct eye exposure to lamp while it is on.
Always disconnect from power source before
servicing or replacing lamp or fuse and be sure to
replace with same lamp source.
Caution!
There are no user serviceable parts inside the unit. Do not open the housing or attempt any
repairs yourself. In the unlikely event your unit may require service, please contact
CHAUVET®.
Please read these instructions carefully, which includes important
information about the installation, usage and maintenance.