O
PERATING
I
NSTRUCTIONS
The COLORsplash™ is a DMX-512 controllable, full RGB color mix par can made up of highly
efficient and super bright leds. There are seven led circles whose intensity can be controlled
individually allowing the creation of an unlimited range of colors.
The LED Splash™ can operate in Stand-Alone, Master/Slave and via DMX-512 control utilizing 7
channels.
Master/Slave Mode
The Master/Slave mode will allow you to link up to as many units you want in a daisy chain fashion. In
this mode, the first unit in the daisy chain will automatically command all other units following.
1. Connect all LED Splash™ units in a daisy chain fashion as described in the section following.
2. Master Unit: Set dipswitch # 10 to the OFF position and set dipswitches 1-9 according to the
speed desired as indicated below in “Dipswitch Options”.
3. Slaves: Set dipswitch # 1 to the ON position and all others to the OFF position.
4. You can also run the fixtures in an automatic stand-alone mode by simply setting all fixtures to run
as master units.
D a i s y C h a i n C o n n e c t i o n
1. Connect the (male) 3 pin connector side of the DMX cable to the output (female) 3 pin connector
of the first fixture.
2. Connect the end of the cable coming from the first fixture which will have a (female) 3 pin
connector to the input connector of the next fixture consisting of a (male) 3 pin connector. Then,
proceed to connect from the output as stated above to the input of the following fixture and so on.
D i p sw i t c h O p t i o n s
D
IPSWITCHES
(
ON
) F
UNCTIONS
10
DMX Enable
Blackout (In absence of DMX)
Slave mode in (Master/Slave mode)
None
Speed 1 (Slow)
9 Speed
2
9, 8
Speed 3
9, 8, 7
Speed 4
9, 8, 7, 6
Speed 5
9, 8, 7, 6, 5
Speed 6
9, 8, 7, 6, 5, 4
Speed 7
9, 8, 7, 6, 5, 4, 3
Speed 8
9, 8, 7, 6, 5, 4, 3, 2
Speed 9
9, 8, 7, 6, 5, 4, 3, 2, 1
Speed 10 (Fastest)
While in Slave mode, pins 1 – 9 are for
fixture addressing
LED-PAR196 User Manual
7
2008-04-02/13:33
