DMX-RT User Manual Rev. 3
O
PERATION
Cue File Setting
The DMX-RT can play the selected cue file one time and then stop (
Shot
)
or continuously loop (
LooP
) the
same cue after it was triggered.
1.
Go to
SEtU
>
rt
.
2.
Select
Shot
or
LooP
.
DMX Sequence File Selection
The DMX-RT can record and play up to 999 different user recorded DMX sequence files. Follow the steps
below to set which file to play when triggered.
1.
Go to
SEtU
>
FILE
.
2.
Select the desired file number to play. (
F000-999
)
Delay Time
This will set the amount of time (0-60 secs) before the DMX-RT can be triggered again.
1.
Go to
SEtU
>
dt
.
2.
Select the desired delay time in seconds. (
00-60
)
Record File Start type
The DMX-RT can initiate recording a DMX sequence file by using DMX (once a value of 001 or higher is
sensed the DMX-RT will start recording) or manually on the control panel using the <
ENTER
> button.
Using DMX as a trigger:
1.
Go to
SEtU
>
rb
.
2.
Select
non
.
Using manual trigger.
1.
Go to
SEtU
>
rb
.
2.
Select
nAnL
.
Record File End type
The DMX-RT can stop recording a DMX sequence file by DMX (once a value of 000 is sensed the DMX-
RT will stop recording) or manually on the control panel using the <
ENTER
> button.
Using DMX as a trigger:
1.
Go to
SEtU
>
rE
.
2.
Select
non
.
Using manual trigger.
1.
Go to
SEtU
>
rE
.
2.
Select
nAnL
.
Record File
After choosing how to start and end the recording...
1.
Go to
rECo
.
2.
Select the desired file number to record (
F000-999
).
3.
To start your recording, follow the recording setup selected above.
Run File
This allows the DMX-RT to run a file manually without having to use a trigger.
1.
Go to
rUn
.
2.
Select the desired file number to play. (
F000-999
)
Software Version
This shows the firmware.
1.
Go to
vEr
.
2.
Select
bxxx
for the software (bootloader) version and
Axxx
for the firmware (application) version.
Содержание DMX-RT
Страница 1: ...DMX RT User Manual...