Chauvet DMX MEGA STROBE III, Руководство пользователя

Страница: 13 / 16

DMX Mega Strobe™ III User Manual
13
6/11/2009 1:02 PM
General Troubleshooting
Symptom Solution(s)
Applies to
Lights
Foggers
& Snow Controllers
Dimmers
& Chaser
Auto shut off Check fan thermal switch reset

Beam is very dim or
not bright Clean optical system or replace lamp
Check 220/110v switch for proper setting

Breaker/Fuse keeps
blowing Check total load placed on device

Chase is too slow Check users manual for speed adjustment
  
Device has no power Check for power on Mains.
Check device’s fuse. (internal and/or external)
  
Fixture is not
responding Check DMX Dip switch settings for correct addressing
Check DMX cables
Check polarity switch settings

Fixture is on but
there is no
movement to the
audio Make sure you have the correct audio mode on the
control switches. If audio provided via ¼” jack, make
sure a live audio signal exists
Adjust sound sensitivity knob
  
Lamps cuts off
sporadically Possible bad lamp or fixture is overheating.
Lamp may be at end of its life.

Light will not come
on after power failure Some discharge lamps require a cooling off period
before the electronics in the fixture can kick start it
again, wait 5 to 10 minutes before powering up

Loss of signal Use only DMX cables
Install terminator
Note: Keep DMX cables separated from power cables
or black lights.
   
Moves slow Check 220/110v switch for proper setting

No flash Re-install bulb, may have shifted in shipping

No light output Check slip ring & brushes for contact
Install bulb
Call service technician

Relay will not work Check reset switch
Check cable connections

If you still have a problem after trying the above solutions, please contact CHAUVET Technical
Support.
Technical Support
Address: Service Dept.
3000 N 29th Ct, Hollywood, FL 33020 (U.S.A.)
Support (Email): tech@chauvetlighting.com
Telephone: (954) 929-1115 - (Press 4)
Fax: (954) 929-5560 - (Attention: Service)
Website: http://www.chauvetlighting.com