DIAMOND
strip™ User Manual
13
2010-01-26/14:56
DMX Control Mode
Operating in a DMX Control mode environment gives the user the greatest flexibility when it comes to
customizing or creating a show. In this mode you will be able to control each individual trait of the
fixture and each fixture independently.
Daisy Chain Connection
1. Connect the (male) 3 pin connector side of the DMX cable to the output (female) 3 pin connector of
the first fixture.
2. Connect the end of the cable coming from the first fixture which will have a (female) 3 pin
connector to the input connector of the next fixture consisting of a (male) 3 pin connector. Then,
proceed to connect from the output, as stated above, to the input of the following fixture and so on.
DMX mode setup
1.
Press the
Mode
button, until the display reads [
SYS
]; then, press
Enter
.
2. Press the
Up
/
Down
buttons until the display reads [
S dAd
]; then press
Enter
.
3. Set the DMX address value by using the
Up
/
Down
buttons. Press
Enter
.
4. Press the
Mode
button.
5. Press
Enter
to make changes permanent.
3 Pin XLR DMX
cable
Continue…
You can use the
Master/Slave link to
control
multiple units
as one DMX device.
Read the
instructions
on the
following page.
DMX Output
DMX Input
Universal DMX
Controller
