LED-PANEL4 User Manual
7
2006-03-22/12:38
Free-standing option
S
ETUP
Power
The LED-PANEL4
™
can operate
in voltages between 100V~240V 50Hz or 60Hz. It is equipped with
an auto sensing transformer.
To determine the power requirements for a particular fixture, see the label affixed to the back plate
of the fixture or refer to the fixture
’
s specifications chart.
A fixture
’
s listed current rating is its average current draw under normal conditions.
All fixtures must be powered directly off a switched circuit and cannot be run off a rheostat
(variable resistor) or dimmer circuit, even if the rheostat or dimmer channel is used solely for a 0%
to 100% switch.
Before applying power to a fixture, check that the source voltage matches the fixture
’
s
requirement.
All fixtures must be connected to circuits with a suitable Earth Ground.
Po w e r C a b l e C o n f i g u r a t i o n
C
ABLE
(EU)
C
ABLE
(US)
P
IN
I
NTERNATIONAL
B
ROWN
Black
Live
L
B
LUE
White
Neutral
N
Y
ELLOW
/G
REEN
Green
Earth
EG (Ground)
Mounting
O r i e n t a t i o n
Diffused surface should face the
environment with the back side either
flush mounted or using flush mount
hardware provided. No specific
orientation is required. The product is
not intended to be used in place of
ceiling tiles. Please make sure to
follow proper load bearing limitations if
mounting on the ceiling.
R i g g i n g
The fixture includes 4 plastic wall
mounting accessory pieces for wall
surface mount.
1. Draw a screw hole template on a large
piece of vellum or transparent paper
for best alignment.
2. Place paper against the mounting surface and drill
holes or mark the surface for drilling.
3. Mount plastic accessory and screw into place.
4. Hang Panel.
