4BAR™ Tri USB User Manual Rev. 2
Page 15 of 20
Master/Slave
Mode
(wired)
The Master/Slave mode allows a single 4BAR™ Tri USB product (the master) to control
the actions of one or more 4BAR™ Tri USB products (the slaves) without the need of a
DMX controller. The master product will be set to operate in either standalone mode or
with the footswitch, while the slave products will be set to operate in Slave mode. Once set
and connected, the slave products will operate in unison with the master product.
Configure the products as indicated below.
Slave products:
1. Press
<MENU>
repeatedly until
3-CH
or
15CH
shows on the display.
2. Press
<ENTER>
to accept.
3. Set the DMX address to
d 1
.
4. Connect the DMX input of the first slave product to the DMX output of the master
product.
5. Connect the DMX input of the subsequent slave products to the DMX output of the
previous slave product.
6. Finish setting and connecting all the slave products.
Master product:
1. Set the master to operate in either Automatic or Sound-Active mode.
2. Make the master product the first product in the DMX daisy chain.
•
Configure all the slave products before connecting the master to the daisy
chain.
•
Never connect a DMX controller to a DMX string configured for Master/Slave
operation because the controller may interfere with the signals from the master.
•
Do not connect more than 31 slaves to the master.
Master/Slave
Mode
(D-Fi™ USB)
The D-Fi™ USB allows a single 4BAR™ Tri USB product (the master) to control the
actions of one or more 4BAR™ Tri USB products (the slaves) without the need of a DMX
controller or DMX cables. The master (transmitter) product will be set to operate in either
standalone mode or with the footswitch, while the slave (receiver) products will be set to
operate in Slave mode. Once set and connected, the slave products will operate in unison
with the master product.
Configure the products as indicated below.
Slave products:
1. Press
<MENU>
repeatedly until
3-CH
or
15CH
shows on the display.
2. Press
<ENTER>
to accept.
3. Set the DMX address to
d 1
.
4. Set D-Fi™ USB to receive on a specific channel, 1–16.
5. Plug in the D-Fi™ USB.
6. Finish setting and configuring all the slave products.
Master product:
1. Press
<MENU>
repeatedly until the DMX personality the slaves are set to shows on
the display.
2. Press
<ENTER>
to accept.
3. Set the DMX address to
d 1
.
4. Set the master to operate in either Automatic or Sound-Active mode.
5. Set the D-Fi™ USB to transmit on the D-Fi™ channel the slaves are receiving on.
6. Plug in the D-Fi™ USB.
•
All products must be set to the same DMX personality, DMX address, and D-Fi™
channel.
•
Configure all the slave products before configuring the master to transmit.
•
Never connect a DMX controller to a D-Fi™ channel configured for Master/Slave
operation because the controller may interfere with the signals from the master.
Содержание 4BAR Tri
Страница 1: ...User Manual ...
