EN
2
Ovation H-265WW QRG Rev. 4
QUICK REFERENCE GUIDE
AC Power
This product has a auto-ranging power supply that can work with an input voltage range of 100–240 VAC, 50/60 Hz.
AC Plug
Replacing The Fuse
1.
Disconnect this product from power.
2.
Using a Phillips #2 head screwdriver, unscrew the fuse holder cap from the housing.
3.
Remove blown fuse and replace with a good fuse of the same type and rating.
4.
Screw the fuse holder cap back in place and reconnect power.
DMX Linking
The Ovation H-265WW will work with a DMX controller using a 5-pin DMX serial or a hard wire connection. A DMX Primer
is available from
DMX Connection
The Ovation H-265WW uses a 5-pin DMX or a hard wire data connection for its DMX personalities:
1
,
2
,
3
or
6
. See the
User Manual for information about connecting and configuring the product for DMX operation.
Master/Slave Connection
The Ovation H-265WW uses the DMX data connection for its Master/Slave mode. See the User Manual for information
about how to connect and configure the product for master/slave operation.
RDM (Remote Device Management)
Remote Device Management, or RDM, is a standard for allowing DMX-enabled devices to communicate bi-directionally
along existing DMX cabling. The Ovation H-265WW supports RDM protocol that allows feedback to monitor temperature
and changes to
DMX Address
,
DMX Personality
,
Dimmer Mode
, and
LED Frequency
menu options. Download the
for more details.
Wireless Operation
In optimal conditions, the Ovation H-265WW can operate up to 300 m (900 ft) away from the W-DMX transmitter. The W-
DMX receiver in the Ovation H-265WW must be paired with the W-DMX transmitter for wireless operation.
Initial Setup
1.
Turn the W-DMX transmitter on.
2.
Connect the W-DMX transmitter to a DMX controller.
3.
Place the Ovation H-265WW within 300 m from the W-DMX transmitter.
4.
Disconnect any DMX cable from the Ovation H-265WW.
5.
Turn the Ovation H-265WW on.
Configuration
1.
From the Ovation H-265WW control panel, go to
DMX Address
.
2.
Select the start address, as with any other DMX compatible product.
3.
Go to
Wireless Setting > Receive On/Off.
4.
Select On. (The Signal Strength Indicator will show a ? in front of the bars)
5.
Press the reset button on the W-DMX transmitter. (The Signal Strength Indicator on the Ovation H-265WW will
show a
ϟ
in front of the bars for 3 seconds while a connection is established.
Connection
Wire (U.S.)
Wire (Europe)
Screw Color
AC Live
Black
Brown
Yellow/Brass
AC Neutral
White
Blue
Silver
AC Ground
Green/Yellow
Green/Yellow
Green
To eliminate unnecessary wear and improve its lifespan, during periods of non-use completely
disconnect the product from power via breaker or by unplugging it.
!