Setup And Installation
Page 8 of 21
Net-X User Manual Rev. 4
Setup And Installation
3.
AC Power
Net-X has an internal auto-ranging power supply that works with an input voltage range of
100–240 VAC, 50/60 Hz. To determine the power requirements for the Net-X refer to the
label affixed to the product or Technical Specifications.
The listed rating indicates the maximum current draw during normal operation. For more
information, download Sizing Circuit Breakers from the Chauvet website at
www.chauvetprofessional.com.
•
Always connect this product to a properly grounded and protected circuit
•
Never connect this product to a rheostat (variable resistor) or dimmer ci cuit,
even if the rheostat or dimmer channel serves only as a 0 to 100% swi ch.
•
To eliminate unnecessary wear and improve its lifespan, during pe ods of non-
use completely disconnect the product from power via breake or by unplugging
it.
Fuse Replacement
The Net-X uses a T 250 mA, 250 V fuse accessible from the bac of the product. To change
the fuse, do the following:
1. Disconnect the product from power.
2. With a flat-head screwdriver, unscrew the fus ho der ap from the
housing.
3. Remove the blown fuse.
4. Replace with a fuse of the same type and ating.
5. Screw the fuse holder cap back in plac and reconnect power.
•
Disconnect the product from powe before replacing the fuse.
•
Always replace a blown fus with another of the same type and rating.
www.carlosmendoza.com.mx