Chattanooga Adapta ADP400, Руководство пользователя

Страница: 16 / 24

13
setup
AttAchiNg trActioN uNit stANd to tAble
Attach the Pivot Plate to the table
and fasten with the two supplied
1/4-20 screws.
NOTE:
Make sure that the holes
of the Pivot Plate and the
table are aligned before
securing the Pivot Plate to
the table.
Attach the two supplied 1/4-20
ESNA nuts to each screw and
tighten with a 7/16" wrench.
Attach the Traction Unit Stand to
the aligning holes of the Pivot Plate
and the table.
Place the two supplied 13 mm
flat washers underneath the Pivot
Plate.
Attach the two supplied 9/16"
ESNA nut and tighten with a 9/16"
wrench.
Position the adjustment knob
of the Traction Unit Stand to the
desired degree of the Pivot Plate.
Adapta® ADP400