13
Baying cabinets together
GT-Series GlobalFrame Gen 2 Cabinets can be bayed (fastened) together with both side panels in place,
with a shared side panel between cabinets, or with no side panels between cabinets, depending on
installation requirements. Cabinets must be the same height and depth.
1.
The cabinet doors do not need to be removed from the cabinet. The baying bracket and hardware
is accessible on the rear with the rear doors fully open. The front door should be opened
approximately 90 degrees until the hole in the edge of the front door aligns with the screw used to
attach the baying bracket (see below).
2.
Use the supplied hardware and a #2 Phillips screwdriver to attach the baying bracket (included in
the hardware kit) to the first cabinet. The bracket will bay any two cabinets that are the same
height and depth side-by-side.
3.
Move the second cabinet so that the cabinets are aligned. This may also require adjusting the
leveling feet if the second cabinet was not set at the same level as the first cabinet.
4.
Use the supplied hardware to attach the baying bracket to the second cabinet.
5.
Repeat steps 1-4 for the other end of the cabinet.
