KIT, SINGLE FAN, CUBE-IT
IIS-740972, 01/19/18, Rev. 1, CPI/SJG
800-834-4969 (USA & Canada) • www.chatsworth.com • [email protected]
For international phone numbers, see our website or contact CPI Tech Support.
This drawing contains proprietary and confidential information and is protected by U.S. and international law. Unauthorized reproduction, disclosure or use of the drawing
or the information therein is expressly forbidden except as agreed to in writing by Chatsworth Products, Inc.
Page 1 of 2
Installation Instructions
Safety Information
WARNING:
Improper use of this product or failure to follow
these instructions may result in equipment damage, personal
injury, or death. Read and understand all instructions for proper
installation and use of this product.
WARNING
: Disconnect electrical power before working on or
installing fan assemblies.
WARNING
: Never work alone when potentially hazardous
conditions exist and never install damaged equipment.
WARNING
: Hazardous moving parts. Keep away from rotating
fan blades.
Intended Use
The Fan Kit is designed to provide cooling to the equipment installed in CPI’s
CUBE-iT Cabinet by drawing pre-filtered air into the cabinet. Drawing air into
the cabinet slightly pressurizes the cabinet and provides additional protection
from dust and debris. The fan kit can be installed on the left or right sides of
the cabinet. Filters can easily be changed without any need to access the
inside of the cabinet.
Tools Required
Phillips #2 Screwdriver
1 – Cooling Fan with Wire Grill
Included Parts and Hardware
1 – Mounting Plate
1 – Filter and Plastic Retainer
1 – Blanking Panel
1 – Power Cord (Plug style may vary)
8 – M5 Pan Head Screws
1 – M4 Ground Screw