4.
Adjusting the Bracelet
Adjust the bracelet by removing links in a simple procedure involving just two small screwdrivers.
Carefully insert the blades of the screwdrivers in opposing screw slots and turn counterclockwise
to loosen and remove retaining screw from connecting shaft .
Pull connecting shaft straight out to open the bracelet and repeat the procedure for each link
that needs to be removed.
Reassemble by reinserting connecting shaft to close the bracelet and secure with screw .
A
B
B
B
A
A
B
NOTE*
When removing more than one link, alternate from either side of the buckle
so the buckle and watch case remain relatively centered on the bracelet.
If the screwdrivers are too small or too
large, they may damage the screws and
will be more likely to slip and damage
the bracelet’s finish.
Take care not to over tighten the screws or mar the bracelet’s fine finish.
NOTE*
Use flat blade screwdrivers
that fit the screws.
Place a small drop of LOCTITE
®
222 or clear nail polish on the
thread to prevent it from
loosening and getting lost.
screw
