Charnwood W629, Руководство оператора

Страница: 7 / 20

Slide the hose support clip onto the rear guide rail
and lock it into place.
Fit the dust collection hose to the saw guard and
the spigot on the rear extraction point. Secure in
place with the two hose clamps provided.
Clip the hose into the support arm to hold it clear
of the table.
It is strongly recommended you use a dust
extractor at all times, by connecting a hose to
the 100mm outlet.
Failure to use an extractor will require
stopping the machine regularly to clean out of
the internal parts of the extraction hood, to
avoid causing damage.
Fit the two support arms which will carry the guide
rail for the sliding carriage.
These are bolted to the left hand side of the table
with four countersunk bolts. Fit the wide guide rail
extrusion by sliding it over the heads of the eight
securing bolts.
Position the sliding carriage guide rail so that the
back edge of the rail is level with the back side of
the rear guide rail. Ensure the guide rail is parallel
to the saw blade before tightening the eight nuts.
You may need to reposition the rail when making
mitre cuts.
Before fitting the sliding carriage it should be
noted that the two outboard bearing wheels are
mounted on eccentrics.
Should it ever be necessary their position can be
adjusted with the aid of a 14 mm spanner.
The guide rail is fitted with front and rear travel
stops.
Move the rear travel stop to the back of the slot.
Remove the front stop completely and fit the
sliding carriage onto the guide rail so that the four
bearing guides are located in the matching
grooves along the sides of the rail.
Replace the front stop.