Charnwood W575, Руководство по эксплуатации

Страница: 9 / 12

9
Troubleshooting
Problem Possible cause Possible solution
Motor is slow or weak
- voltage from source is - Request a voltage
low check from local
power company
- Windings are burned - Have the motor
out or open checked, repaired or
replaced
- NVR switch is defective - Have the NVR
checked, repaired or
replaced
- Circuit is overloaded - Do not use other
with appliances, lights appliances or
or other electrically electrically powered
powered equipment equipment on the same
circuit when using the
thicknesser
Motor regularly overheats - Voltage from source
- Request a voltage check
Is low from the local power
company
-
Dull blades - Replace the blades
- Sawdust inside machine - Clean out the
is blocking airflow thicknesser
- Feed rate too fast - Reduce the feedrate
- Too much material - Reduce the amount
being removed per pass of material being
removed per pass
Motor does not start -No power at mains - Check the mains
Supply supply
- Defective switch, motor - Have the machine
or mains lead inspected by a suitably
qualified person
- Overload has cut the - Leave the machine to
power to the motor cool for 10–15 minutes
Poor finish on work piece - Dull/ damaged blades - Resharpen or replace
Blade
-
Blade blocked by - Clean the blades
Chipping’s or resin
- Too much material - Make more passes
being removed per pass with smaller cuts
- High moisture content - Dry out workpiece or
in work piece use a different piece
Un-parallel workpiece
- Blades incorrectly set - Reset blades parallel
After cut