OPERATING INSTRUCTIONS
Turn the volume control on the remote control to it’s off position.
Switch on the power using the on/off switch on the Active speaker rear panel.
Adjust the volume control to increase the output sound level to your preferred level.
WARNING: Always turn the unit on and wait for a moment before turning the volume control
up. High signals levels can damage the system on startup.
The system accepts line-level audio signals from sources such as PCs, Notebooks, CD/DVD
players, Minidisc players, iPod, Tuners etc.
After use turn off the volume control, which disconnects the amplifier, and turn off the power
switch on the rear plate which turns the internal power supply.
TROUBLE SHOOTING
If the system is not operating correctly, please check the table below: If the problem persists
contact your AV reseller immediately and disconnect the system from the power.
Problem
Checks to be made
No Sound from either speaker
•
Check that the mains supply is switched on at
the wall socket
• Check that the power switch at the amplifier rear
panel of the active speaker is switched on
• Check that the volume control is turned up
• Check that the audio cables to your audio source
are connected properly
• Check that the audio source is active and playing
No sound from Passive speaker
Check the Mini jack cable connection at the active
speaker and the connection at the passive
speaker end
SPECIFICATIONS
Output Power
15 Watts x 2
Drive Units
4" x 2 + 1.5"x2
Impedance
4 ohms
Frequency response
20Hz – 20 kHz
Separation
>35 dB
Signal/noise Ratio
>60d B
Input Sensitivity (10%
THD)
<600 mV
Distortion THD
<0.3%
Dimensions (mm)
143x252x173 mm
Power Supply
230 Volt/ 50Hz
STANDARDS
CE Approved product
BS 1363 standard for Electrical Plug alternatively a Europlug to CEE 7/16 plug rated at
3A/230VAC
Restriction of the Use of Certain Hazardous Substances in Electrical and Electronic
Equipment Regulations 2005 (RoHS)
Waste Electrical and Electronic Equipment (WEEE) Directive (2002/96/EC).
