Brummel hook separation system
Art. no. HKar141
- User manual -
1. Connect the loop of the speed system
cord (1) to the speed system Brummel
hook using one each of the supplied
curved pins and elastic O-rings as shown
in the pictures. Caution: The first step is
to pass the speed system cord through
the O-ring! Loop or tie the free end of
the separation system cord (2) to the belt
chamber of the separation carabiner.
2. To adjust the correct lengths of the
speed system cord and the separation
system cord before takeoff, you need a
second person to help you. Put on the
harness, connect it to the paraglider
risers and sit down on the ground. While
the assisting person is holding up the
risers, first determine the correct length
of the speed system cord on the harness.
Then set the separation system cord
sufficiently long so that it is not under
tension at full acceleration.
3. During a subsequent release test of the
separation carabiner with the risers
under tension, the separation system
cord must tighten and pull off the curved
pin, causing the speed system cord to
disconnect.
Installation
The existing Brummel hooks on the speedsystem of the paraglider
are replaced by the special speed system Brummel hooks. To be
able to attach the speed system Brummel hooks, the speed system
cords must each have a loop at the end.
spliced loop are included with the Brummel
hook separation system. These can be
used provided they can be attached to the
installed speedbar.
Alternatively, the speed system cords
already present on the harness can
be used if it is possible to remove the
Brummel hooks attached to them.
If the existing speed system cords are
not yet equipped with loops, loops
with a length of about 3 cm can be
knotted in.
Speed system cord
Separation system cord
Scope of delivery
1 pair
Speed system Brummel hooks made of Titanal,
breaking load 190 daN
1 pair
Curved pins made of high-strength aluminum alloy,
with spliced-in separation system cord
1 pair
Special O-rings made of elastic silicone rubber
1 pair
Replacement O-rings
1 pair
Speed system cords made of Dyneema, with spliced
loop
A speed system separation link is required to automatically
disconnect the speedbar after rescue parachute deployment when
separation carabiners are used.
This Brummel hook separation system is recommended when the
harness and the paraglider are connected by means of Brummel
hooks.
Speed system cords made of Dyneema with
