"Charging on the run" indications
During periods in which the engine starting battery is being charged and maintained by the
engine driven charging system, amber and red LED indicators are provided which display
the state of the integrated "ProXtra" circuitry that controls the flow of current to additional
batteries.
Indications are as follows:
CHARGING CRANKING BATTERY-This amber LED is illuminated whenever the voltage of
the engine starting battery is in excess of 13.0 Volts.
CHARGING ADDITIONAL BATTERIES-This red LED is illuminated during periods when
the "ProXtra" circuitry is allowing charging current to flow to additional batteries.
INSTALLATION INSTRUCTIONS
All Charging Systems International battery charging systems are designed to be perma-
nently mounted and have no mounting restrictions.
Do not make any electrical connections to the power supply (AC) or to a battery (DC) until
the mounting process has been completed.
Check for fit and appropriate thickness of mounting area. It is recommended that you choose
a flat surface. If a compartment wall is chosen, make certain its strength is adequate.
Use the mounting flanges of the charger to mark locations for starter holes. Drill a 1/16"
inch hole at each marked location. Then, utilize all stainless steel screws which have been
provided and install the charger securely being cautious not to over tighten the screws.
Silicon sealer should be used to secure and waterpoof the screw holes.
5
INITIAL CHARGING PHASE –
5 RED LED’S
ABOVE 13.0 VOLTS –
4 RED LED’S
ABOVE 14.0 VOLTS –
3 RED LED’S
BATTERY 80% CHARGED –
2 RED LED’S
FINAL CHARGE PHASE –
1 RED LED
CHARGE CURRENT OFF-MONITORING –
1 GREEN LED
IMPORTANT NOTICE
The mounting bracket of
the system contains
keyholes that are
designed so that some
screws can be started
before putting the
charger into place.
