© 2021 Charge Amps AB
Installation manual for
Charge Amps
Aura Dual Pole Mount
Doc. Nr: 130129
Rev 01
Address:
Charge Amps AB
Frösundaleden 2B
SE-169 75 Solna
Sweden
Contact:
+46 (0)8 55 11 2000
[email protected]
www.chargeamps.com
Org. No. 556897-7192
Registered office: Solna
5
About Aura Dual Pole Mount
By adding the Pole Mount, specifically designed for Aura, you open up the possibilities for
installing two chargers on a 60 mm outer diameter pole e.g. an existing motor heater pole.
Contact your supplier for more information about your specific Aura Dual Pole Mount.
Contents of the package
In the packaging, below is included:
•
Aura Dual Pole Mount
•
Installation kit, zip-lock bag containing O-ring 60 x 2mm, 4 pcs. of M6 bolts, 4
pcs. of M6 nuts, 8 pcs. M6 washers, 5 pcs M4 screws, 1 tooth washer M4 and 6
pcs. of M6 pin stop screws.
NOTE: The four M6 x 20 mm screws included in the Aura product kit will be used
for mounting Aura on the pole mount.
•
Installation manual
•
Data sheet of the included terminal block
Provided by the installer
•
Torx drive T30 (used for M6 x 20 mm screws included in the Aura product kit)
•
Torx drive T20 (used for M4 x 8 mm screws)
•
SDK PZ2 (Terminal block)
•
2 x M6 socket wrench size 10 with extender (used for M6 screws / nuts)
•
Hex key M6 (used for M6 pin stop screws)
•
Screwdriver (manual or power tool)
•
Proper cables for L1
–
L3, N, PE and necessary tools for cutting, stripping etc.
Before installation
Make sure that the right conditions and materials are in place before installation. The
installation must be done in accordance with the instructions in this installation manual as
well as basic safety precautions.
