X610 Series
5 IN-00020 [REV001] 201709
Turning Scale On/Off
To turn the remote display on and off, press the
[ON/OFF]
button. When turn on the remote display will display
and
start flashing, then the display shows “0” and enters the active weighing mode.
To turn the scale base on and off, push the
[ON/OFF]
switch button that under the bottom of the scale base.
Notes:
If display appear
with
flash, and “0” does not show, press
[Channel Switch]
button to match up
with the scale’s channel. If display channel is setup on Channel-1, please select Channel-1 for scale base as well.
Channel setting instructions please see SETTINGS for instructions.
Tare Operation & Setting
When power on the scale and if the weight on the scale is within the initial zero tolerance, the scale will display zero
automatically.
Although there is nothing on the pan and the display is not zero, press
[TARE]
button or hand over the
Tare sensor
to
set zero to the scale.
Changing Units of Measure
In weighing mode, use
[UNIT]
to display the next available measuring unit. Repeat process to scroll through all units.
SETTINGS
Channel Setting
Before match up Channel of remote display and scale base, make sure they are turn off and signal range within 10
meters (30 feet).
Remote Display channel setting
Press
[Channel Switch]
button to select the display channel, see illustration below
Remote Display Channel setting
Channel-1
A triangle appears next to the Channel-1
Channel-2
A triangle appears next to the Channel-2
Channel-3
A triangle appears next to the Channel-3
