11
20
12
Inside of cart,
insert rear tank heat shield tabs(w/o holes) into slots on the bottom of upper back panel
.
Attach FireBox lower heat shield to the tank heat shield using two
#8x3/8”
self-tapping screws, shown
A
.
Attach front tank heat shield tabs(w/ holes) under front brace using two
#8x3/8”
self-tapping screws, shown
B
.
#8x3/8” self-tapping screw
Connect each of the wires from the main burner electrodes, and sideburner electrode into the back of the Electronic Ignition
Module.
T
otal (4) connections.
Connect the two wires[(a) and (b)] from the switch wiring harness into the back of the Electronic Ignition Module.
NOTE: Switch terminals are larger than electrode terminals and should only be installed in location shown as (a),(b).
Total (2) connections.
ignition module
Electronic
Heat shield
Left side panel
A
A
B
Release the cap and nut from electronic ignition module. Attach electronic ignition module and heat shield to the cart left
side panel with the nut, shown
A
.
Insert AA battery into ignition module, negative (
-
) end first. Then put on the cap, shown
B
.
Nut
-
+
AA battery
Cap
3
1
2
4
(a)
(b)
Tank heat shield
FB lower heat shield
FB lower heat shield
Tank heat shield
Tab w/ hole
Tab w/o hole
(rear)
(front)
(concave faces up)
Front brace
Upper back panel
Tank heat shield
#8x3/8” self-tapping
screw
side view
B
