463233503 • 7
11. Place the side shelves over the brackets and cross braces
with the wider-spaced shelf holes to the outside (shelf with
trim plate on right side). Be sure the inside shelf holes align
with holes in bowl support bracket. See Fig. 3.
12. To install the side shelf handle, remove the bolt and washer
from one side of the handle (cap remains with handle).
From beneath shelf, place washer onto bolt and insert bolt
through end of shelf bracket, side shelf, and into handle.
Leave bolt loose until other side of handle is attached, then
fully tighten both sides. Repeat for other side shelf.
See Fig. 3.
FIGURE 5
Side
shelf
Shelf bracket,
flat side facing
outward
Lower
hole
Door
bracket
Door
Handle
Hinge
Hinge
hole
Align
holes
To reduce the weight of the grill head, open the grill lid and
remove the packed components. This step requires 2 people
to lift and position the grill head onto the cart.
14. HINT: Slide grill head into cart from the front. Use care to
avoid scratching tops of side shelves. Align the 2 holes
beneath the hang ledge on each side of the grill head with
the 2 holes in the side shelf and bowl support bracket on
the cart. Raise the grill lid and insert 4 of the 1/4x1/2"
Phillips-head screws. Beneath the side shelves, add
1/4" nuts. Do not fully tighten. See Fig. 5.
Grill
head
Hang
ledge
Gas hose
Hang
ledges
rest on
shelves
FIGURE 3
Door
stop
Remove
film
Shelf
handle
13. Attach match lighting stick
and chain to the right rear
leg, below shelf bracket,
using one M4 X 10mm,
self-tapping, Phillips-head
screw. See Fig. 4.
Match
lighting
stick
FIGURE 4
Screw & washer
