Char-Broil Grill 2 Go 11401587, Руководство по эксплуатации продукта

Страница: 6 / 12

Page 6
General Grill Cleaning
Do not apply a caustic grill/oven cleaner
to painted surfaces.
Side Shelves:
• Do not mistake brown or black accumulation of grease and
smoke for paint. Interiors of gas grills are not painted at the
factory (and should never be painted). Apply a strong solution
of detergent and water or use a grill cleaner with scrub brush
on insides of grill lid and bottom. Rinse and allow to
completely air dry.
• Wash with warm soapy water and wipe dry.
Do not use citrisol, abrasive cleaners, degreasers or a
concentrated grill cleaner on plastic side shelves. Damage to
and failure of shelves can result.
CAUTION
• Putting out grease fires by closing the lid is not
possible. Grills are well ventilated for safety
reasons.
• Do not use water on a grease fire. Personal injury
may result. If a grease fire develops, turn regulator
control knob and LP cylinder off.
• Do not leave grill unattended while preheating or
burning off food residue on HIGH. If grill has not
been regularly cleaned, a grease fire can occur that
may damage the product.
CAUTION
FACT:
into the burner tubes attached to the burner. The
spiders spin webs, build nests and lay eggs. The
webs or nests can be very small, but they
are very strong and can block the flow
of gas. Clean burner prior to use after
storing, at the beginning of grilling season
NATURAL HAZARD•SPIDERS
or after a period of one month not being used.
Spiderguards are on the air intakes in an effort to
reduce this problem, but it will not eliminate it! An
obstruction can result in a "flashback" (a fire in the
burner tubes). The grill may still light, but the obstruction
does not allow full gas flow to the burner.
Smell gas.
Burner(s) will not light.
A small yellow flame from burner (should be blue).
Fire coming from around or behind control knob.
Follow the “ ”instructions.
Clean burner often. Use a 12” pipecleaner to clean out
the burner tube. You may also force a stream of water
from a hose nozzle through burner tube to clean them.
IF YOU EXPERIENCE THE FOLLOWING:
1.
2.
3.
4.
STOP!
Immediately turn off gas at LP cylinder!
SOLUTION:
Wait for grill to cool.
Cleaning the Burner Assembly
Burner Flame Check
Light burner. Make sure burner stays
lit while rotating the regulator control
knob from HIGH to LOW. Always
check flame prior to each use.
Sometimes spiders and other small insects climb
1. Turn gas off at regulator control knob and disconnect
LP cylinder.
2. Remove cooking grid and trough.
3. Remove regulator from burner tube by sliding regulator lock to
the right. Hold the lock to the right and pull regulator from the
burner tube. Shown
FIG. A
4. Wipe ceramic electrode with rubbing alcohol and cloth. Clean
burner exterior with soap and water. insert garden hose
(preferably with nozzle), into burner tube forcing water
through tube. Make sure water comes out of every porthole.
Open clogged portholes with a thin wire.
Allow burner to dry
thoroughly and examine portholes. Due to normal wear and
corrosion some portholes may become enlarged, if so replace
burner. If any horizontal cracks appear from porthole to
porthole or large holes (other than portholes) are found
replace burner.
5. If grill is to be stored, coat burner lightly with cooking oil. Wrap
in protective cover to keep insects out. If not storing use
following steps.
6. Reattach Regulator.
7. Replace cooking grid.
8. Before cooking again on grill, perform a
“Leak Test” and
“Burner Flame Check”.
Cleaning The Burner Assembly
HIGH
LOW
Regulator Lock
1. Slide right
2. Pull out
Regulator
A
Regulator Removal
Grill Trough: Wash with warm soapy water and wipe dry.
The grill trough is NOT designed to be used as a cooking
surface.
•