Char-Broil 463250510, Руководство по эксплуатации продукта

Страница: 20 / 28

11
20
12
Inside of cart, insert rear tank heat shield tabs(w/o holes) into slots on the bottom of upper back panel.
Attach FireBox lower heat shield to the tank heat shield using two #8x3/8” self-tapping screws, shown A.
Attach front tank heat shield tabs(w/ holes) under front brace using two #8x3/8” self-tapping screws, shown B.
#8x3/8” self-tapping screw
Connect each of the wires from the main burner electrodes, and sideburner electrode into the back of the Electronic Ignition
Module.
T
otal (4) connections.
Connect the two wires[(a) and (b)] from the switch wiring harness into the back of the Electronic Ignition Module.
NOTE: Switch terminals are larger than electrode terminals and should only be installed in location shown as (a),(b).
Total (2) connections.
ignition module
Electronic
Heat shield
Left side panel
A
A
B
Release the cap and nut from electronic ignition module. Attach electronic ignition module and heat shield to the cart left
side panel with the nut, shown A.
Insert AA battery into ignition module, negative (
-
) end first. Then put on the cap, shown B.
Nut
-
+
AA battery Cap
3
1
2
4
(a)
(b)
Tank heat shield
FB lower heat shield
FB lower heat shield
Tank heat shield
Tab w/ hole
Tab w/o hole
(rear)
(front)
(concave faces up)
Front brace
Upper back panel
Tank heat shield
#8x3/8” self-tapping
screw
side view
B