Char-Broil 12401734, Руководство по эксплуатации продукта, Страница: 5 / 16

Page 5
Leak Testing (1 lb. Disposable)
• During leak test, keep grill away from open flames or sparks
and do not smoke. Grill must be leak tested outdoors in a well
ventilated area.
Leak test must be repeated each time gas cylinder is replaced
or after storage.
Materials needed include clean paint brush and 50/50 soap and
water solution. Use mild soap and water.
Damage to components can
result.
Be sure on regulator is in "OFF" position.
Brush soapy solution onto between regulator pipe
threads and regulator, and burner tube and orifice at .
•
Do not use
household cleaning agents.
1. control knob
3. connection
(B)
IMPORTANT!
If growing bubbles appear, there is a leak. Retighten
If you cannot stop a leak, remove gas
cylinder from regulator and check for
damaged threads, dirt and debris on
regulator and gas cylinder. Also check to
see if anything is obstructing flow of gas at
regulator and gas cylinder openings.
Remove any obstruction that may be
found and repeat leak test.
Order new parts by
giving the serial, model number and name
of items needed to the Grill Service Center
at .
If threads are
damaged on either regulator or gas
cylinder, replace.
1-888-430-7870
connections and repeat
Brush soapy solution onto between gas cylinder
and regulator at .
2. connection
(A)
steps 1 , 2, and 3.
A
B
Propane Cylinder Installation/Removal
Propane Cylinder Installation:
1. Remove cap from end of Propane cylinder (sold separately).
2. Cap should be kept on cylinder when not in use to prevent dirt
and debris from entering Regulator/Valve.
3. Check end of cylinder attachment for dirt and debris. Clean out
if necessary.
4. Insert threaded end of Propane Cylinder into Regulator/Valve
and hand-tighten turning cylinder clockwise as shown below.
DO NOT USE TOOLS! Over tightening can damage threads
on Regulator/Valve.
Propane Cylinder Removal:
1. Turn regulator OFF.
2. Allow Grill to cool.
3. Remove the propane cylinder by turning counter-clockwise until
disengaged from the Regulator/Valve.
4. Install cap on cylinder. Cap should be kept on cylinder when not in
use to prevent dirt and debris from entering Regulator/Valve.
Regulator/Valve Installation/Removal
1. With knob pointing to back of grill, insert Regulator/Valve into
end of burner (A)
Notch in Regulator/Valve MUST engage dimple in end of
burner.
2.Once Regulator/Valve has completely engaged burner, turn
Regulator/Valve clockwise (B) to lock in position with knob
pointing as shown (C).
3. To remove reverse steps.
A
B
C
IMPORTANT: REMOVE PROPANE CYLINDER FROM
REGULATOR/VALVE WHEN NOT IN USE.
Dimple
Red notch Full engagement