Chaparral 2009 Signature 250, Руководство владельца/оператора

Страница: 45 / 148

Four Selector Switches with Three Batteries and Twin
Engines
Models: Signature 350, 330, 310, 290, 280
Note: Signature 350, 330, 310 have two house batteries.
Each of the four battery switches have two positions:
All Switches Off
Power supplied to automatic bilge pump, CO detector (if so
equipped) and stereo memory.
STBD Switch ON
Use only STDB (Main Engine) battery.
PORT Switch ON
Use only PORT (Main Engine) battery.
HOUSE Switch ON
Use only HOUSE battery.
STBD, PORT, and HOUSE Switches ON
Use STDB (Main Engine) and PORT (Main Engine) batteries.
Emergency parallel switch OFF.
Recommended settings are as follows:
1. All Switches Off
When boat is not in use or power is not required, turn all
switches to OFF. The only power supplied at this setting is
the automatic bilge pumps, carbon monoxide detector (if
equipped), stereo memory and high water alarm.
2. STBD Switch ON
To start the engine, place switch in ON position. With this
setting, power will now be supplied to your boat from the
STBD (Main Engine) battery.
3. PORT Switch ON
To start the engine, place switch in ON position. With this
setting, power will now be supplied to your boat from the
PORT (Main Engine) battery.
4. HOUSE Switch ON
For cabin or accessory power, place the switch in the ON
position. Power will now be supplied to your boat from the
HOUSE battery.
Note: Chaparral does not recommend leaving all three
switches on when the engine is off. This will drain both batter-
ies and you will not have a starting battery.
5. STBD, PORT, and PARALLEL Switches ON
If the batteries are low, you still have the option of starting the
engines by combining the output from both batteries.
Note: When recharging a low battery, be sure to run the engine
for a sufficient amount of time to fully recharge the battery.
Note: Chaparral does not recommend any other settings than
mentioned because of possible damage to batteries or engine
alternator.
3-3
Figure 3.1 270, 250 Battery Panel