F
lashing a tune to your vehicle
1. Plug the nGauge into the OBDII Port located under the dash on the driver’s side.
2. Once the nGauge is plugged in and powered ON, select Tuning.
3. Select Load Tune.
4. Find the tune you wish to put on the truck.
5. Hit the √ button.
If you purchased a switch on the fly tune, hit the check mark under the file that says “SOTF”
(switch on the fly).
2017-2018 Powerstrokes will have typically 3 files: SOTF, TRANS and Kam Reset.
2011-2016 Powerstrokes will have 1 file only “SOTF”.
If you purchased a single tune you will only have one file if it is a 2011-2016. Flash in the appropriate file whether it is a single “Tow”
tune or “street” tune. If it is a 2017-2018 you will see three files. One will list “Tow” or “street” one will say “Trans”. You will flash in
the single tune first. Then flash in the “Trans” file after that. If you end up not liking how the transmission is shifting later down the
road. You can flash in the “Kam Reset” to start from scratch.
2017-2018 - If you see a “Kam reset” file, this file is to only be used to relearn the transmission shifting points. Once the file is flashed
in, you need to flash back in the “Trans” file right away.
CAUTION!
Do NOT drive the truck on “Kam Reset”. This file is simply used
to wipe the transmission’s memory!!
