16
DIGITAL ATSC HDTV TV TUNER
TV Remote Control
8.5 Extra feature on the Remote
z
There are 5 learning functions including TV PWR, VOL+,VOL-,CH+ and CH-.
z
Step to Configure the “TV VOL+,VOL-,CH+ and CH-” key on your remote control.
z
Purpose: The learning key can be used to control your TV through the learning procedure. Below
steps provide the steps:
1.
Put your TV remote control and the STB remote control on firm and stable surface (for example,
the living room table)
2.
Aim two remote controls head to head as shown below. Keep 2~3 inches distance in between.
3.
On the STB remote, press and hold the “SET” key for at least 3 seconds till LED flash then
release it.
4. On the STB remote, press TV PWR button once.
As LED lights , the STB remote control enters the “learning” mode.
5. On the TV remote, press also TV PWR button once.
As LED flashes , it stands for learning procedure successfully.
You can keep learning more functions i.e. VOL+,VOL-,CH+ and CH- . The operational method
follows from step4.
6. Once you complete learning step, press SET button on the STB remote to quit learning mode.
7. Try to operate TV set by using the learning buttons on the STB remote as follows.
a. For Power on-off, push TV PWR blue button.
b. For Volume Up-and-Down, use learning buttons, Vol+ and Vol-.
Vol- for lowering volume and Vol+ for increasing volume.
c. For Channel Up-and-Down, use learning buttons, CH+ and CH-.
CH+ for increasing Channels CH- for decreasing Channels.
8. If your TV set has no response , please start from step 1 again and slightly increase or decrease
the distance between two remote.
Note:
z
During learning mode, the STB remote is waiting to receive remote command from outside. If no
other remote command is given to the remote for 15 seconds or any one key is pressed, the
remote will exit the learning mode.
z
Some TV remote control may be so complex as to your learning invalidly.
z
This function supports over 80% TV remote controls on the market.
Содержание CB-7001
Страница 1: ......
