Connections
10Scene wall plates feature a 7 pin push lock cable connector which is wired
using the below table. 10Scene Wall mounts should be wired before connecting
to QuickQ Rack/Gateway Interface.
Pin
Name
Description
Recommended wiring
1
POWER +
Positive power in/out
CAT5e Orange pair IN (twisted together
2
POWER +
Positive power in/out
CAT5e Orange pair OUT (twisted together)
3
10Scene H
10Scene signal High in/out CAT5e Blue/white wire IN/OUT
4
10Scene L
10Scene signal Low in/out CAT5e Blue wire IN/OUT
5
10Scene 0V 10Scene 0V (NOT USED)
NOT USED
6
POWER -
Negative power in/out
CAT5e Brown pair IN (twisted together)
7
POWER-
Negative power in/out
CAT5e Brown pair OUT (twisted together)
When looking at the rear of the 10Scene Pin 7 is at the
top and Pin 1 at the bottom.
Pin 7
Pin 1
If daisy chaining, twist 10Scene High IN and the OUT wires together and connect to Pin 3,
and twist 10Scene Low IN and the OUT wires together and connect to Pin 4.
