EN
2
Assembly
Stand:
1. Screw the standing shaft into the stand.
Rear net assembly:
1. Screw the blade fastening screw out in clockwise direction
and screw the net fastening screw in anti-clockwise direction.
2. Fix the rear guard onto the three pillars of the motor front
shell.
3. Screw the net fastening screw tightly in clockwise direction.
Fan blade:
1. Put the fan blade onto the electrical axle center. The axle
center bolt must be pressed to the end of the concave notch
at the back of the fan blade. They must be tallied completely.
2. Screw the screws into the electrical axle center in anti-clock-
wise direction.
Front net assembly:
1. Put the hook of the front guard ring on the top of rear net.
2. Put the rear net into the front guard ring to make them tally
completely.
3. Tighten the fastening screw on the lower part of the front
guard ring.
Operating instructions
• Remove all items of packaging from the fan.
• This fan has 3 types of speed control, (0 -OFF, 1 – LOW, 2 – MEDIUM, 3 – HIGH)
• You can choose the up and down angle freely.
• If you press the oscillate knob, the fan begins to wave. Pull the knob to stop the wave.