Champion 93020, Руководство пользователя и инструкции по эксплуатации

Страница: 16 / 31

13
REV 93020-20120419
ENGLISH 93020
OPERATION
Before Each Use Inspect the Log Splitter
1 . Check the hydraulic oil level and visually inspect all
hoses, attachments and cylinder for loose fittings,
leaks, cracks, fraying or other damage .
2 . DO NOT operate the log splitter if there is any
indication of damage .
3 . Inspect the engine and make sure the oil level is
correct before operating . If the engine is equipped
with a spark arrestor, clean and inspect it regularly
(follow spark arrestor maintenance schedule) .
4 . The tires need to be fully inflated and in good repair .
Reference the tire sidewall for recommended tire
pressure .
Towing Log Splitter Safety
1 . Always check local and state regulations regarding the
requirements for towing, licensing and lights .
2 . Before towing make sure the log splitter is correctly
and securely attached to the vehicle and the safety
chains attached with enough slack to allow for turning .
3 . Support leg must be pinned in the “UP” position for
towing .
4 . Never exceed the max . travel speed of 45 mph . Towing
the log splitter at speeds greater than 45 mph could
result in serious injury or death . Always adjust your
towing speed according to the terrain and conditions .
5 . Always disconnect the log splitter from the towing
vehicle before operating .
Log Splitter Location
This log splitter must have at least seven feet of
clearance from combustible material . Leave at least
three feet of clearance on all sides of the log splitter to
allow for adequate cooling, maintenance and servicing .
DO NOT place the log splitter near vents or intakes
where engine exhaust fumes could be drawn into
occupied or confined spaces .
ONLY operate the log
splitter outdoors.
DO NOT over inflate tires . Serious injury can result
if tires explode .
DO NOT tow the log splitter if the tires are worn or
will not hold air .
DO NOT exceed the maximum 45 MPH (72 KPH)
towing speed .
WARNING
Vertical Operating
Position
Work Zone
Horizontal Operating
Position
Wo
rk
Zo
ne
Log Splitter Location Cont’d.
For Vertical Operation:
– Remove the beam lock-pin from the beam
bracket
– Use handle on cylinder to rotate beam to vertical
position
– Insert beam lock-pin in the pivot bracket
NOTE
The log splitter needs to be on a dry level surface with
good footing . DO NOT work on mud, ice, tall grass,
brush or snow .
Only operate log splitter from work zones shown below .