8
TRAP ASSEMBLY INSTRUCTIONS (continued)
STEP 3.
THROWING ARM ASSEMBLY (FIG-4).
Line-up three holes in Throwing Arm (A) with three
holes in Arm Support. Insert three M10 x 20mm Hex
Bolts (J-4) from bottom through Throwing Arm Support
and Throwing Arm. Add 10mm Flange Nuts (J-5) and
tighten securely.
STEP 4.
FLIGHT CONTROL RAIL ASSEMBLY (FIG-4).
Line-up threaded holes in Flight Control Rail (D) with
top holes in edge of Throwing Arm (A). Attach Control
Rail with three Round Head Screws (J-3). Do not fully
tighten screws until the Target Clip is installed (Step 5)
NOTE: It is normal for these screws to be somewhat
difficult to turn.
STEP 5.
TARGET CLIP ASSEMBLY (FIG-5).
After attaching the Flight Control Rail in the previous
step, slide the Target Clip (F) between the Flight Control
Rail (D) and the Throwing Arm (A) and tighten the three
screws (J-3).
STEP 6.
MAINSPRING ASSEMBLY (FIG-6)
Drop M10 x 100mm Hex Bolt (J-9), threaded end first, into Mainspring
(E) through largest opening so that threaded end comes out of opposite
tapered end. Make sure Throwing Arm (A) is pointing forward. Connect
hook end of Mainspring (E) through hole in Swivel Yoke. Put threaded
end of Hex Bolt (J-9) through hole in Rear Bracket. Add the Nylon
Shoulder Washer (J-10), 10mm Flat Washer (J-11), and 10mm Hex Nut (J-
12) and finger tighten. Adjustment of Mainspring tension for throwing
targets will be done later.
FIGURE 5
Target Clip (F)
Throwing Arm (A)
Round Head S
crew
s
(J-3)
10mm Flange
Nuts (J-5)
Throwing Arm (A)
Fligh
t Con
trol R
ail (D
)
Arm Support
M10 x 20mm Hex Bolts (J-4)
FIGURE 4
NOTE: Throwing Arm, Flight Control Rail and Target
Clip are PRE-ASSEMBLED. Steps 3-5 provided below
for reference only (assembly by user is not required).
10 MM X
125 MM Hex
Bolt (K-‐4)
Nylon
Shoulder
Washer
(K-‐10)
10 MM Flat
Washer (K-‐
5)
10 MM
Hex Nut
(K-‐7)
Swivel Yoke
Mainspring
Assembly (E)
Cotter Pin
Washer
Rear Bracket
Trap Arm Faces Forward
FIGURE 6
FIGURE 6
Washer
Cotter Pin
Rear Bracket
Trap Arm Faces Forward
10 MM
Hex Nut
(J 12)
Nylon
Shoulder
Washer
(J-10)
10 MM Flat
Washer(J-11)
Swivel Yoke
Mainspring
Assembly (E)